Section 9 #1 #2 #3 #4 Whirlpool Tub, Combination Tub, Air Tub Operating Instructions

For Platinum series whirlpool tubs

NOTE: Do not start pump until all jets are submerged water level should be 3" above highest jet.

Dual on/off air button control operates each pump/jet action

independently. Press the button once and the pump will turn on.

Press the button again and the pump will turn off.

Three speed pump control:

To operate the 3 speed control, turn the dial to change the speed.

H(High) to M(Medium) to L(Low)

Air Control volume knob:

Turning the knobs clockwise will reduce the volume of air jet pressure.

Neck Massage pillow

Turning the dial clockwise will reduce the pillow jet pressure down to 5%

*Before operating the Neck Massage pillow, make sure the white lycra

pillow cover is covering the gray pillow.

Underwater mood light on/off air button:

Press the button once and light turns on.

Press the button again and the light turns off.

Bulb replacement:

See page 12 for bulb replacement and lens instructions.

Inline heater control:

See page 12 for operating instructions.

Microflow and Soul Soother jet pressure adjustment:

Turning the jet face clockwise will reduce the pressure

up to 95% off.

Ultra Adjustaflo jet pressure adjustment:

Turning the jet nozzle will reduce the pressure up to 95% off.

Hydroclean Sanitation System

1. This unit meets the requirements of NSF Protocal P308 ozone sanitation systems for jetted bathtubs and

pedicure footbaths.

2. The Hydroclean will operate automatically whenever the pump is running. You will notice a slight sweet

smell and bubbles will be coming out of the dedicated Hydroclean jet on the side wall of the tub about

1 1/2" in diameter.

3. No maintenance or cleaning of the unit is required. The life of the unit is approximately 9000 hours of use.