Section 7

Whirlpool Tub, Combination Tub, Air Tub Operating Instructions

For Bronze, Silver, Gold and Air Massage series whirlpool tubs

Whirlpool Tub, Combination Tub, Air Tub USER INFORMATION – PLEASE NOTE:

The whirlpool tub action may cause even small amounts of bubble bath or shampoo to foam excessively in an Air Tub or any version of our  Jet Tubs. Exercise moderation in experimenting with different soap products and follow the whirlpool tub system cleaning instructions. The user should do no servicing of this product. There are no user serviceable parts. All air controls and air switches are located on the lip of the tub. These are the only controls that should be used by the consumer. Do not change or alter any of these controls under any circumstances. This unit can be only be serviced by a qualified service representative.

Motors are self-lubricating and no lubrication is required. Refer to the Maintenance Instructions (page 12)

Note: Do not start pump until all jets are submerged; water level should be 3" above highest jet

Whirlpool Tub, Combination Tub, Air Tub BATHSIDE CONTROL SYSTEMS

On/Off controls:

The On/Off air button for the pump/jet action

Press button once and pump will start

Press button again and pump will turn off

Air control volume dial:

Turning the knobs clockwise will reduce

the volume of Air jet pressure inside the tub

Three speed pump control:

(Standard on the Gold series)

To operate the 3-speed control turn the

dial to change speed:

H=High M=Medium L=Low

Optional underwater mood light:

One on/off air button operates the pump, while the

additional air Button operates the underwater mood light.

Press button once and the light will turn on

Press the button again and the light turns off

Aromassage series Airbaths

#1.1st press: The blower starts at maximum speed, LED: ON

2nd press: The blower stops, LED: ON until the purge cycle

stops. Approximately 20 minutes.

#2.1st press: Speed goes up, LED ON when pressing

Release pressure at the desired speed.

#3.1st press: Speed goes down, LED: ON when pressing

Release pressure at eh desired speed

#4.1st press: Slow pulsation cycle ON, LED: ON

2nd press: Quick pulsation cycle OFF, LED: flashes

3rd press: Pulsation cycle OFF, LED: OFF

Your blower is equipped with an integrated air

heating element, built in electronic control, variable

speeds, pulsation cycle, a 20 minute delay and an

automatic drying cycle, which will activate

approximately 20 minutes after the blower has

been activated. The DELUXE Aromassage system

will activate an automatic drying cycle approx 20

minutes after the bath has had water in it, even if

the blower was not activated.